![]() Much better! I didn’t have to apply a lot of pressure and the dirt was easy to remove. The worst spots are near the grizzly logo and bolts, so let’s treat this spot first. I only skated this board under sunny conditions so maybe this time I have more success. This grip tape is about 15 months old and I treated this board well. ![]() Time to grab another board and repeat the process. The sides are impossible to clean without damaging the tape and most of the dirt specks won’t come off. I rather have dirty grip tape than damaging the maple wood, do not use water! This grip tape is like 4 years old so it’s impossible to get it perfectly clean without using soap or water. It’s probably because the before and after images you see advertised that aren’t very realistic. The end result is disappointing and I expected more to be honest. In this case, the week-old spot was easy to remove but I had to apply a lot of pressure on to get some results. Remove the dirty residue from the block when needed. Cleaning the Grip Tapeįirmly rub the belt sander block back and forth in a straight line. Note that a week before I stepped into so dirt on purpose, it’s the spot in the back. You could use a brush to remove some of the sand on the surface and you’re ready to go. Some recommend to remove the trucks, but it isn’t necessary. ![]() I used my table in my garden and used a towel to prevent any damage, it also helps to keep your board in place. A brush to remove the last bits of dirt.A glove if you worry about grinding your fingers or knuckles.So let’s put this to the test and see what happens. Keep in mind that you can’t clean it until it looks brand new. This is by far the best method to clean your grip tape. I need to point out that buying new grip tape is cheaper, but this is a one-time purchase that will last you a long time. Repeat until you cleaned all the dirty spots or you are happy with the result.Remove the residue on the stick and continue rubbing the grip tape surface.Rub it firmly in a straight line on the grip the surface and see if the dirt comes off.Cut off a piece you can still hold firmly or just use the whole block or use the whole block.Be careful not to grind your knuckles into the grip tap. It requires some time and effort but you can make it look like new. You can get them for around 10 bucks online. It’s relatively cheap and does the job well even in extreme cases. There are a few ways to clean grip tape but the cheapest and most effective way is to use belt sander cleaner.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |